Can you recoat an epoxy floor

For the second coat you do not have to worry about how much epoxy is absorbed by the concrete. The coverage rate for this coat will be very consistent because it is being applied over another layer of epoxy.

This is your high build coat, so pay great attention to covering only the square footage the epoxy was mixed for. This will ensure the maximum dry film thickness as advertised by the epoxy manufacturer. After you have rolled back each mix of your color coat, start applying the vinyl color flakes.

There is no need to stress about applying all the flakes within the working window of the epoxy. You will be OK as long as you start applying the vinyl flakes 10 minutes after the final roll back. Keep the spiked shoes on so that you can walk out onto the floor, unless you are covering small sections at a time.

This means that you can reduce your surface preparation time and make quick work on large projects. Additionally, the powerful, high-performance vacuum included reduces dust cleanup and creates a cleaner, healthier environment. Thoroughly vacuum the floor, then go over it with denatured alcohol or other cleaning solution and a disposable microfiber mop. This will get the best results, ensuring you have a clean area to start.

Your email address will not be published. Hi there! I am extremely passionate about trying new things and putting myself out there. Skip to content Skip to footer. Holes and Chips Repair The first step to recoating an epoxy surface is to repair holes and chips on the surface.

Clean the Floor with Grease-Cutting Detergent A mixture of warm water and grease-cutting detergent can be used for cleaning the floor.

Use a Floor Buffer You need an grit sanding screen, screening attachment, and a floor buffer to recoat an epoxy floor. Paint the Edges Use a paint brush for applying paint to the edges of the cleaned surface. Leave a Reply Cancel reply Your email address will not be published. About Me Hi there! Young Leaders.

Mix enough clear epoxy finish with hardener to cover the floor and spread it in the same way that you spread the color coat. Allow the clear coat to cure for the recommended time, which is usually from 12 to 24 hours. If you're coating the garage floor, wait 72 hours before driving your car on it. Don't recoat a finish that is peeling or extensively cracked, because the new finish won't adhere properly.

Strip the old finish. Surfaces coated with epoxy can be slippery. You can make the floor safer to walk on by adding nonskid granules to the clear coat before you spread it. Once you mix the paint with the hardener, you have a limited time to use it.